How Wigs are Manufactured?

Wigs are not only worn because of natural reasons, that can be loss of hair due to illness, but wigs are also worn for cosmetic reasons and also for convenience. Wigs online help people to not only enhance their look but these also help people save their time, money and effort. The wigs that we usually wear are manufactured either through machining processes or can be hand-made. Both these methods include the same processes.

The processes involved in the manufacturing of wigs include;

1. Preparation of the Hair:

Preparation of the hair strands is the first process involved in manufacturing of the wigs. The first thing that is checked in this process is whether the individual hair strand is in the same direction as the others or not. The next step in this process is hackling. This is drawing out the very short hair strands which is then followed by tying of hair into bundles to securely hold them together. This step is then followed by inspection of hair to look for nits and if found, the hair is then boiled in acetic acid solution while combing it using a steel-toothed nitting machine. Then the hair is washed in hot and soapy water and rinsed by clean water several times, afterwards it is set to dry in air. It is then again followed by hackling. It is then given the required type, straight or curly and different shades of colors are applied to give the hair a natural look.

2. Preparation of the Pattern:

The next process of manufacturing the wigs is to prepare the pattern of the wig. The first in this process is to give the wig online the perfect fit. For a custom-made wig, the size of the person’s head is taken, and the foundation is prepared on these dimensions. The six basic measurements that are taken includes; the circumference is measured a half inch above the hairline at the nape of the neck, the next is from the hairline at the front of the head to the hairline at the nape of the neck, another measurement between points just in front of each ear, then across the crown of the head, then straight across the back of the head and then the nape of the neck. This helps in formation of a pattern on a paper.

3. Making the foundation:

The third process is the making of the foundation. The edge is created from fine-mesh silk netting of the desired color. The crown is then cut from nylon, cotton or silk. The pattern created is then placed on a wooden head-shaped block. The net helps in the meshing of the foundation by sewing pieces together. The created foundation is held tightly in place with the help of springs sewn into it.

4. Knotting:

The third process after creation of the foundation is knotting. The prepared hair is attached to the foundation in this process. In this process, around 30,000 to 40,000 knots are prepared and can take up to 40 hours. To secure these knots, the wig surface is pressed, and this is done by a heated iron.

5. Styling

This is the last and the final process. To carry out the styling, the prepared wig is pinned on a block that is soft. A wet comb s used for combing the hair. After styling, net is used to cover the wig and dried in an oven.

This is how a perfect hairpiece is manufactured and you can find the hairpiece of your choice at https://www.artnature.asia/.